在線咨詢
官方二維碼
當前位置：
2020.05.29
焦化發電機組廠家調壓器要如何使用
為了保護發電機組正常發電，焦化發電機組廠家提醒大家注意調壓器的使用。
In order to protect the normal power generation of the generator set, the coking generator set manufacturer reminds everyone to pay attention to the use of the voltage regulator.
1.在啟動之前，應該斷開所有輸出開關。
1. All output switches should be disconnected before starting.
2.將速度提高到額定速度，將端子電壓提高到額定電壓。觀察其穩定性。加載后原動機速度可能發生變化，頻率可能低于額定頻率。原動機的速度可以再次調整到額定頻率。
2. Increase speed to rated speed and terminal voltage to rated voltage. Observe its stability. The prime mover speed may change after loading, and the frequency may be lower than the rated frequency. The speed of the prime mover can be adjusted to the rated frequency again.
3.在發電機停止前，應切斷負載，機器應停止無負載。
3. Before the generator stops, the load shall be cut off and the machine shall stop without load.
4.三相發電機應注意三相負荷或電流平衡，避免單相負荷運行或負荷不平衡嚴重使用，造成發電機組或調壓器損壞。
4. Attention shall be paid to three-phase load or current balance of three-phase generator to avoid damage of generator set or voltage regulator caused by single-phase load operation or severe use of load imbalance.
以上內容是焦化發電機組廠家為您介紹使用調壓器的一些注意事項，可供您在實際操作中參考。
The above contents are some precautions of using voltage regulator for you, which can be used for your reference in actual operation.